HONDA metro 21 User Manual

Page 42

Advertising
background image

- 37 -

Problem

Possible Causes

Corrective Action

1. The wire is not connected to

the spark plug.

1. Connect the wire to the spark

plug.

2. The spark plug is pitted, fouled,

or the gap is incorrect.

2. Check the spark plug and adjust

the gap if necessary. Replace
the spark plug if it is pitted,
fouled, or cracked.

3. The throttle lever is not in the

Fast position.

3. Move the throttle lever to the

Fast position.

Engine runs rough

4. The air filter element is dirty

and is restricting the air flow.

4. Clean the air filter pre-cleaner

and/or replace the paper air
filter.

1. The blade is bent or is out of

balance.

1. Balance the blade. If the blade

is bent, replace it.

2. The blade mounting bolt is

loose.

2. Tighten the blade mounting bolt.

3. The underside of the lawn

mower deck contains clippings
and debris.

3. Clean the underside of the lawn

mower deck.

Lawn mower or engine
vibrates excessively

4. The engine mounting bolts are

loose.

4. Tighten the engine mounting

bolts.

1. All four wheels are not at the

same height.

1. Place all four wheels at the

same height.

2. The blade is dull.

2. Sharpen and balance the blade.

3. You are mowing in the same

pattern repeatedly.

3. Change the mowing pattern.

Uneven cutting pattern

4. The underside of the lawn

mower deck contains clippings
and debris.

4. Clean the underside of the lawn

mower deck.

1. The throttle lever is not in the

Fast position.

1. Move the throttle lever to the

Fast position.

2. The cutting height is too low.

2. Raise the cutting height.

3. You are mowing too fast.

3. Slow down.

4. The grass is wet.

4. Allow the grass to dry before

mowing.

Discharge chute plugs

5. The underside of the lawn

mower deck contains clippings
and debris.

5. Clean the underside of the lawn

mower deck.

1. The self-propel drive cable is

out of adjustment or is
damaged.

1. Adjust the self-propel drive

cable. Replace the cable if
necessary.

Lawn mower does not self-
propel (Self-Propelled Models
Only)

2. There is debris under the belt

cover.

2. Clean the debris from under the

belt cover.


Advertising