Set-up, Tools required, Unpacking – HONDA HS520AS User Manual
Page 41: Assembly
39
SET-UP
Tools Required
12 mm wrench, 10 mm wrench, and a Phillips screwdriver
Unpacking
1. Remove all the cardboard. Inspect the loose parts. Missing parts
can be obtained from the Honda dealer who sold you the
snowthrower.
2. Loosen and remove the curved-head bolt, flange nut, and starter
bracket from the lower handlebar. Do not discard the hardware.
Assembly
1. Install the handlebar
with the hardware
shown. Tighten the
flange nuts securely.
Qty.
Description
Part number
4
Curved head bolt 8 x 40 mm
90109-VA4-000
4
Flange nut, 8 mm
94050-08000
4
Curved washer, 9 mm
90501-898-000
3
Phillips head shoulder screw 6 x 12 mm
90112-V10-000
3
Flange nut, 6 mm, Nylock
90303-V10-000
2
Cable tie (AS model only)
32901-VB5-A00
2
Key
35110-766-003
8 x 40 mm
CURVED HEAD
BOLT (4)
8 mm FLANGE
NUT (4)
9 mm CURVED
WASHER (4)