HONDA HS520AS - Manual (Page 42)

SET-UP
40
2. Pull the clutch cable enough
to insert the “Z” fitting on the
cable through the auger clutch
lever as shown here. Check
the lever free play as shown
on page 27.
3. Install the starter bracket using the hardware removed from step 2
on the previous page. For the HS520AS, snap the starter rope into
the rope guide on the handlebar and install the two cable ties. Trim
the cable ties to a length of 3/8 inch (10 mm).
“Z” FITTING
AUGER
CLUTCH
LEVER
HS520AS HS520A
ELECTRIC
STARTER BRACKET
FLANGE
NUT
CURVED
HEAD BOLT
ROPE GUIDE
FLANGE NUT
CURVED
HEAD BOLT
CABLE TIE (2)
STARTER BRACKET
9 mm
CURVED
WASHER