HONDA HS520AS - Manual (Page 19)

OPERATION
17
CLEARING SNOW
1. Press down on the handlebar to raise the front of the snowthrower
slightly. Roll the snowthrower over to the snow area.
2. Use the chute guide handle (page 10) to
adjust the direction for the discharged
snow to travel.
3. Engage the auger clutch lever. The
auger will begin to spin.
4. Tilt the snowthrower forward
slightly with the handlebar to
engage the auger into the
snow. The auger will then pull
the snowthrower forward and
discharge the snow.
5. To stop, lower the handlebar
slightly, then release the
auger clutch lever.
ENGAGE
AUGER
TILT FORWARD SLIGHTLY