Hitachi CP-X327W - Manual (Page 15)

14
STANDBY/ON INPUT KEYSTONE RESET
LANP TENP POWER
1
Make sure that the power cord is firmly and
correctly connected to the projector and outlet
2
Turn on the projector's power
Set the power switch to [ | ] (ON). The projector will go
to STANDBY mode and the POWER indicator will light to
solid orange.
3
Press the STANDBY/ON button (control
panel or remote control)
• The projector begins warming up and the POWER
indicator blinks green.
• The POWER indicator stops blinking
and lights to solid green once the
projector's power is completely on.
4
Remove the lens cap
The picture is projected.
STANDBY/ON INPUT KEYSTONE RESET
LAN P TEN P POW ER
STANDBY/ON INPUT KEYSTONE RESET
LANP
TENP
POWER
power switch
KEYSTONE
RESET
LANP TENP POWER
POWER indicator
STANDBY/ON
VIDEO
ASPECT
HOME
END MUTE PAGE DOWN
KEYSTONE FREEZE
OFF
ON
PAGE UP VOLUME MAGNIFY
AUTO BLANK
RGB SEARCH
STANDBY/ON
TURNING ON THE POWER
Control panel
Precautions
Connect all devices to be used to the projector prior to turning on the power.
WARNING When the power is ON, a strong light is emitted. Do not look into the
lens.
Turn the
power on/off in
right order.
• Power on the
projector before the
computer or video
tape recorder.
• Power off the
projector after the
computer or video
tape recorder.
NOTE