Document Outline

• Revision History
• Copyright
• Trademark Information
• Disclaimer of Liability
• About This Manual
  • Introduction
  • Organization
  • Intended Audience
  • Conventions
  • Inspecting Your Shipment
  • FCC Class B Compliance
  • EU Compliance
• Installation
  • Overview
  • Unpack the Modem
  • Determine What You Need
  • Connect Cables
    • Connect the 10/100Base-T Port
  • LED Status Indications
  • Rebooting the Modem with the Reset Button
• Accessing the Web Interface for Modem Management
  • Assign IP Addresses
  • Set Up the Web Browser
  • Accessing the Modem Web Pages
• Configuring the LAN
  • Before You Begin
  • Configure the LAN
  • Configure DNS Relay Mode
  • Configure DHCP Server Mode
• Configuring the WAN
  • Before You Begin
  • Configure a New WAN Session
    • Set Up an RFC 1483 Bridged Session
    • Set Up an RFC 1483 Routed Session
    • Set Up a PPPoA or PPPoE Routed Session
    • Permanently Save Sessions
  • Edit a WAN Session
• Configuring System Parameters
  • Before You Begin
  • Assigning User Access
  • Add a Default Gateway
  • Add Static Route Entries
  • Add SNMP Communities
  • Change Spanning Tree Setting
  • Saving Changes
  • Rebooting the Modem
• Configuring DSL Parameters
  • Before You Begin
  • Complete a G.shdsl Quick Configuration
  • Complete a DSL Advanced Configuration
• Implementing a Point-To-Point LAN Extension
  • Before You Begin
  • Complete a Quick Installation
    • Configure for Central-Office Mode
    • Change the LAN IP Address for the Central-Office Modem
  • Complete a Custom Configuration
    • Configure the Remote Modem
    • Configure the Central-Office Modem
  • Verify Connectivity
• Configuring NAT
  • Before You Begin
  • Configure NAT
• Managing the Modem
  • View System Status
    • View Modem Status
    • View System Log
  • View WAN Statistics
  • View LAN Statistics
  • View SmartCNCT Security Statistics
  • View ATM Statistics
  • View DSL Statistics
    • View G.shdsl Link Statistics
    • View G.shdsl Error Counters
  • Manage Software and Configuration
    • Update System Software
    • Reset to Factory Defaults
• Command Line Interface Access
  • Connect to the Console Port
    • Access the Command Line Interface
    • Access through the Console Port
  • Access through a Telnet Session
    • Set Up the LAN
  • Manage WAN Sessions
    • Add a New Session
    • Set Up an RFC 1483 Bridged Session
    • Set Up an RFC 1483 Routed Session
    • Set Up a PPPoA or PPPoE Routed Session
    • Permanently Save Sessions
    • Edit an Existing Session
  • Manage DSL
    • Configure G.shdsl Parameters
    • View G.shdsl Configuration
    • Monitor G.shdsl Statistics
  • Restoring Factory Defaults
  • Saving the Current Configuration
  • Updating System Software
  • Viewing System Information
  • Rebooting the Modem
• Specifications
  • Overview
  • Data Specifications
  • Default Session Parameter Values
  • Hardware Specifications
  • Connector Pinouts
  • Rate VS reach
• Product Support
• Glossary
• Certification and Warranty
  • Limited Warranty
  • Modifications
  • FCC Class A Compliance
  • Safety Standards Compliance