Apple Xserve (Slot Load) Instruction Manuals and User Guides
We have 2 Instruction Manuals and User Guides for Xserve (Slot Load) Apple
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 88 |
| Size: | 2.54 MB |
Show table of contents
Read manual
Document Outline
- Contents
- Introducing Xserve
- Xserve Overview
- Preparing to Install Your Server
- Installing Your Server in a Rack
- Getting Ready to Install
- Preparing the Server for Installation
- Installing the Server in a Four-Post Rack or Cabinet
- Installing the Server in a Short Four-Post Rack
- Installing the Server in a Two-Post (Telco) Rack
- Disconnecting Cables From the Server’s Back Panel
- Preparing the Server for Software Setup
- Using Your Server
- Installing or Replacing Server Components
- Specifications
- Processor and Memory Specifications
- Dimensions and Operating Environment
- Optical Drive Specifications
- Ethernet Specifications
- FireWire Specifications
- USB Specifications
- Serial Port Specifications
- PCI Video Card Specifications
- Power Supply
- Power Requirements for Devices You Can Connect
- System Clock and Battery
- Safety, Maintenance, and Ergonomics
| Recognized languages: | English |
|---|---|
| Pages: | 8 |
| Size: | 119 KB |
Show table of contents
Read manual
Document Outline
- Overview of Xserve Setup and Safety
- Removing the Server From Its Packaging
- 1 Open the carton, remove any foam or other packaging, and fold back the plastic covering the ser...
- 2 With one person holding the server on each side, carefully lift the unit and place it on a table.
- 3 Remove the protective faceplate from the server’s front panel by unscrewing the thumbscrews at ...
- 4 If there is a small bracket in the optical drive slot at the top right side of the server’s fro...
- 5 Remove any plastic film from the front and rear of the server’s cover.
- Summary of Hardware Installation
- Where to Find Instructions for Xserve Hardware and Software
- Software Update for Xserve
- Removing the Server From Its Packaging