Document Outline

• Contents
• Electromagnetic Compatibility (EMC)
  • Introduction
  • Installation and use
  • Assessment of area
  • Methods of reducing emissions
    • Mains supply
  • Maintenance of cutting equipment
  • Cutting cables
    • Equipotential bonding
    • Earthing of the workpiece
  • Screening and shielding
• Warranty
  • Attention
  • General
  • Patent indemnity
  • Limitation of liability
  • National and local codes
  • Liability cap
  • Insurance
  • Transfer of rights
• Specifications
  • Introduction
  • Torch configurations and weights
  • 45° Duramax Hyamp long handheld torch dimensions
  • 90° Duramax Hyamp long handheld torch dimensions
• Torch Setup
  • Consumable life
  • Long handheld torch components
    • Duramax Hyamp 45° long handheld torch
    • Duramax Hyamp 90° long handheld torch
  • Choose the hand torch consumables
    • Drag-cutting 105/125 A consumables
    • Drag-cutting 45 A and 65 A consumables
    • Gouging consumables
    • FineCut consumables
  • Install the hand torch consumables
  • Connecting the torch lead
• Operation
  • Using the hand torch
  • Operate the safety trigger
  • Hand torch cutting guidelines
  • Start a cut from the edge of the workpiece
  • Pierce a workpiece
  • Gouge a workpiece
    • Gouge profile
    • Varying the gouge profile
    • 125 A gouging profile chart
  • Common hand-cutting faults
• Component Replacement
  • Duramax Hyamp 45° long handheld torch components
  • Duramax Hyamp 90° long handheld torch components
  • Disconnect the power, gas supply, and torch
  • Replace the handle
    • Remove the handle
    • Install the handle
  • Replace the front shell
    • Remove the front shell
    • Install the front shell
  • Replace the trigger assembly
    • Remove the trigger assembly
    • Install the trigger assembly
  • Replace the start switch
    • Remove the start switch
    • Install the start switch
  • Replace the torch body
    • Remove the torch body
    • Install the torch body
  • Replace the pilot arc wire
    • Remove the pilot arc wire
    • Install the pilot arc wire
  • Replace the cap-sensor switch
    • Remove the cap-sensor switch
    • Install the cap-sensor switch
  • Replace the extension tube
    • Remove the extension tube
    • Install the extension tube
  • Replace the torch lead
    • Remove the torch lead
    • Install the torch lead
  • Replace the quick disconnect housing
    • Remove the quick disconnect housing
    • Install the quick disconnect housing
• Maintenance and Parts
  • Routine maintenance and troubleshooting
    • Perform routine maintenance tasks
    • Inspect the consumables
    • Basic troubleshooting
  • Duramax Hyamp long handheld torch replacement parts
    • Full torch assembly, 45° torch
    • External components, 45° torch
    • Internal components, 45° torch
    • Full torch assembly, 90° torch
    • External components, 90° torch
    • Internal components, 90° torch
    • Duramax Hyamp hand torch consumables
      • Drag cutting
      • Gouging
      • FineCut
    • Accessory parts