Document Outline

• About This Guide
  • Audience
  • Conventions
  • Documentation
    • Web Access for Documentation
  • Requesting Technical Support
    • Self-Help Online Tools and Resources
    • Opening a Case with JTAC
• Planning an Installation
  • Installation Roadmap
  • IDP Configuration Basics
    • IDP Sensor Placement
    • IDP Sensor Deployment Mode
    • NetScreen-Security Manager
• Hardware Overview
  • IDP Sensors
    • IDP 75 Sensor
    • IDP 250 Sensor
    • IDP 800 Sensor
    • IDP 8200 Sensor
  • Traffic Ports (Forwarding Interfaces)
    • Configurable NIC States
      • Normal State
      • NIC Bypass State
      • NIC Bypass and Cable Choices
      • External Bypass Unit State
      • NICs Off State
    • Peer Port Modulation
  • Management Ports
  • Hard Drives and USB Ports
  • Power Supplies
  • IDP Sensor LEDs
    • System Status LEDs
    • Management and High Availability Port LEDs
    • Traffic Port LEDs
    • Hard Drive LEDs on Front Panel
    • Power Supply LEDs on Back Panel
• Installing the Sensor
  • General Installation Guidelines
  • Rack Mounting the IDP Sensor
    • Required Tools
    • Mounting Using Device Rack Rails
    • Mounting Using Midmount Brackets
  • Connecting Power
• Configuring the IDP Sensor
  • Initial Configuration Options
    • Simple Configuration
      • Simple Configuration Settings
      • Simple Configuration Values
    • Advanced Configuration
  • Connecting to the Sensor
    • Using the Console Serial Port to Configure the Sensor
    • Using the Management Port to Configure the Sensor
      • Connecting Directly Using the Management Port
      • Connecting Remotely Using the Management Port
    • Simple or Advanced Configuration Using the Management Port
      • QuickStart Simple Configuration
      • ACM Advanced Configuration
  • Connecting Forwarding Interfaces
  • Verifying Traffic Flow
  • Connecting the High Availability Port
• Adding the Sensor to NSM
  • Adding Your Sensor to NSM
  • Checking the Status of Your Sensor
• Updating Software on the Sensor
  • Updating IDP Sensor Software Using NSM Firmware Manager
    • Loading a Sensor Image into NSM
    • Upgrading Sensor Software
  • Updating IDP Sensor Software Without NSM
  • Reimaging the IDP Sensor
• Servicing the Device
  • Replacing a Power Supply (IDP 800, and 8200 Only)
    • Remove a Power Supply
    • Install a Power Supply
  • Replacing a Hard Drive (IDP 800 and 8200 Only)
    • Remove a Hard Drive
    • Install a Hard Drive
• Advanced Configuration
  • Advanced Deployment Modes
    • Bridge Mode
    • Router Mode
    • Proxy-ARP Mode
  • IDP High Availability Deployment Modes
• Specifications
  • IDP 75 Technical Specifications
  • IDP 250 Technical Specifications
  • IDP 800 Technical Specifications
  • IDP 8200 Technical Specifications
  • Safety Compliance
  • EMI Compliance
  • Immunity
• Index
  • A
  • B
  • C
  • D
  • E
  • H
  • I
  • L
  • M
  • N
  • P
  • Q
  • R
  • S
  • U
  • V