Lincoln Electric POWER FEED SVM185-A Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for POWER FEED SVM185-A Lincoln Electric
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 108 |
| Size: | 8.53 MB |
Show table of contents
Read manual
Document Outline
- Master Table of Contents
- Safety
- Section A - Installation
- Section B - Operation
- Section C - Accessories
- Section D - Maintenance
- Section E - Theory of Operation
- Section F - Troubleshooting and Repair
- Symptoms
- The ammeter on the POWER FEED® 25M does not function properly even though the STATUS LEDs are steady green.
- The display and/or indicator LEDs do not change when their corresponding switches and or knobs are activated or turned.
- The mode and/or settings change while welding under normal conditions.
- The wire feed speed is consistent and adjustable, but runs at the wrong speed.
- The unit shuts off while welding or attempting to weld. The STATUS LED is alternating between red and green every second. The unit tries to recover after 30 seconds and may repeat sequence.
- The feeder does power up - no display, no cold feed.
- No shielding gas.
- Inconsistent wire feeding or wire not feeding but drive rolls turning.
- Variable or "hunting" arc.
- Poor arc starts with sticking or"blast-offs", weld porosity, narrow and ropy looking bead.
- The wire feed speed/amperage and voltage/trim display work during preset but show nothing during welding.
- Major physical or electrical damage is evident when the sheet metalcover(s) are removed.
- No wire feed, solenoid or arc voltage. The STATUS LED's are steady green.
- No control of wire feed speed. All STATUS LEDs are steady green.The preset wire feed speed is adjustable on the front panel.
- No welding arc voltage when the gun trigger is activated. The wire feeds normally and the gas solenoid functions properly. The STATUS LEDs are steady green on the wire drive unit.
- The wire feed speed does not change when welding current is established. The WFS stays at the run-in speed. The STATUS LEDs are steady green.
- The purge switch does not activate the gas solenoid, but gun trigger closure in the MIG or pulse modes does activate the solenoid. The LEDs are steady green on the power source, and wire drive unit.
- The COLD INCH/GAS PURGE switch does not turn on the wire drive motor but gun trigger closure in the MIG or Pulse modes does activate the wire drive motor. The LEDs are steady green on the power source, and wire drive unit.
- The voltmeter on the wire feeder does not function properly even though the STATUS LEDS are steady green.
- The displays are blank (not lit). The wire feeds when the gun trigger is activated.
- The dual procedure is not functional when using the remote Dual Procedure switch. The STATUS LEDs are steady green on the power source, and wire drive units.
- Section G - Electrical Diagrams