Document Outline

• UNDERSTANDING THE CANOPY T1/E1 MULTIPLEXER
  • USING THIS USER GUIDE
    • New in This Issue
    • Using the Latest Information
    • Searching This User Guide
    • Interpreting Typeface and Other Conventions
    • Getting Additional Help
    • Sending Feedback
  • INTRODUCTION TO CANOPY T1/E1 MULTIPLEXER
    • Ethernet Interface
    • Standards
    • IDU Physical Description
    • Rear Panel
    • Front Panel
• Status LEDS
  • Features
    • Specifications
• Physical Specifications
• Technical Specifications
  • CONFIGURATION SETTINGS FROM CANOPY FACTORY
    • Bit Handling Capability
    • License Keys
    • Power Adapters
  • PRODUCT LABELS
  • FUNCTIONAL DESCRIPTION OF THE CANOPY T1/E1 MULTIPLEXER
    • Channel Modes
• T1 Channel Mode
• E1 Channel Mode
  • Encoding
• Alternate Mark Inversion (AMI)
• The 1 in 15 Requirement (AMI)
• Binary Eight Zero Substitution Coding
• High Density Bipolar Order Three Encoding
  • Signaling
    • Timing
• Master and Secondary Clocks
• Loss of Clock Signal
• Timing Modes
• Loopback Timing Mode
• Recovered Timing Mode
• Network Timing Scenarios
  • Ethernet Throughput
    • VLAN Support
    • Round-Trip Packet Delay
    • Alarms
• INSTALLING AND CONFIGURING YOUR CANOPY T1/E1 MULTIPLEXERS
  • SAFETY INFORMATION
    • Compliance
    • Lightning Protection
    • Electrocution Hazard
    • Power Supply Unit
  • INSTALLATION PROCEDURES
    • Package Contents
    • Preparing for Installation and Setup
    • Mounting the Canopy T1/E1 Multiplexer
    • Connecting the Canopy T1/E1 Multiplexer
    • Connecting Power to the Canopy T1/E1 Multiplexer
  • INITIAL CONFIGURATION PROCEDURES
    • Installing Software from the CD-ROM
    • Using EMS Software to Configure the Unit
    • Accessing the CLI using a PC + HyperTerminal
    • Configuring the Canopy T1/E1 Multiplexer using the CLI
    • Creating a Login Account
  • CONFIGURATION PROCEDURES USING THE CLI
    • Logging into the System
    • Changing the Administrator Password
    • Select Line Type T1 or E1
    • Select Line Coding
    • Configure Ports
    • Configure Timing
  • CONFIGURATION PROCEDURES USING THE EMS
    • Logging into the System
    • Changing the Administrator Password
    • Select Line Type T1 or E1
    • Select Line Coding
    • Configure Ports
    • Configure Timing
• MANAGING YOUR CANOPY T1/E1 MULTIPLEXERS
  • REMOTE MANAGEMENT THROUGH CONTROL PORT
  • T1/E1 ALARMS
  • SYSTEM RESET
  • T1/E1 LOOPBACK
    • Invoking a T1/E1 Loopback using the CLI
    • Invoking a T1/E1 Loopback Using the EMS
  • MEASUREMENTS FROM DIAGNOSTICS
  • FIRMWARE UPGRADES
  • LICENSE KEY UPGRADES
  • TERMS OF WARRANTY
    • Software License Terms and Conditions
    • Hardware Warranty in U.S.
  • OBTAINING TECHNICAL SUPPORT
  • INVOKING YOUR WARRANTY RIGHTS
• CANOPY T1/E1 MULTIPLEXER REFERENCE INFORMATION
  • CLI COMMANDS TO GET STATUS INFORMATION
  • REGULATORY COMPLIANCE INFORMATION
    • Federal Communication Commission Declaration of Conformity S
    • Department of Communications – Canada
• Canadian Compliance Statement
  • European Telecommunications Standards Institute
• Statement of Compliance
  • TRADEMARKS, PRODUCT NAMES, AND SERVICE NAMES
  • REFERENCES