Document Outline

• N0RTEL
  • ATTENTION
  • Contents
  • Figures
  • Tables
  • Contents
  • About this document
  • Contents
  • Tables
• 1
  • LAN access overview
    • Product
    • 1.2.2 Entering the interface view
      • —End
    • 1.2.3 Configuring the interface description
    • 1.2.4 Configuring the interval of flow statistics
      • —End
      • —End
    • 1.2.5 Enabling the interface
    • 1.2.6 Checking the configuration
    • 1.3.1 Clearing interface statistics
    • 1.3.2 Debugging the interface
  • Contents
  • MAC address table configuration
    • 2.2.1 Establishing the configuration task
    • 2.2.2 Changing MAC address entries
      • —End
    • 2.2.3 Setting the aging time of a MAC address table
      • End
    • 2.2.4 Checking the configuration
    • 2.3.1 Establishing the configuration task
      • No.
      • Data
    • 2.3.2 Configuring MAC address learning limit rules based on a VSI
    • 2.3.3 Checking the configuration
    • 2.4.1 Example of configuring a MAC address table
      • —End
    • 2.4.2 Example of configuring the MAC address learning limit based on a VSI
      • —End
  • Contents
  • Figures
  • Ethernet interface configuration
    • 3.1.1 Introduction to Ethernet interfaces
    • 3.1.2 Classification of Ethernet interfaces
    • 3.2.1 Establishing the configuration task
    • 3.2.2 Assigning an IP address to an Ethernet interface
    • 3.2.3 Configuring the MTU of an Ethernet interface
      • —End
    • 3.2.4 Configuring the working mode of an Ethernet electrical interface
      • —End
    • 3.2.5 Configuring the speed of an Ethernet electrical interface
      • —End
    • 3.2.6 Configuring the loopback function of an Ethernet interface
      • —End
    • 3.2.7 Configuring the preamble length for packets sent by the Ethernet interface
      • —End
    • 3.2.8 Checking the configuration
    • 3.4.1 Example of configuring an Ethernet interface
      • —End
      • —End
    • 3.5.3 Ethernet interfaces discard packets
  • Contents
  • Figures
• 4
  • VLAN configuration
    • OQ NOTE
    • 4.1.3 Communication between VLANs
    • 4.2.1 Establishing the configuration task
    • 4.2.2 Encapsulating the subinterface with dotlq
      • —End
    • 4.2.3 Configuring an IP address for the subinterface
      • —End
    • 4.2.4 Checking the configuration
    • 4.3.1 Clearing VLAN packet statistics
    • 4.3.2 Debugging the VLAN
    • 4.4.1 Example of configuring different VLANs to communicate through routers
      • —End
    • 4.4.2 Example of configuring VLANs to communicate with non-VLANs through routers
      • —End
  • Contents
    • Full-duplex
    • G
    • GE
    • H
    • Half-duplex
    • L
    • LAN
    • LAN switch
    • M
    • MAC
    • MAN
    • MTU
    • P
    • PING
    • POS
  • Contents
  • Index
    • Nortel Secure Router 8000 Series