Telex PW24 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for PW24 Telex
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 8 |
| Size: | 247 KB |
Show table of contents
Read manual
Document Outline
- PW24
- Turn the transmitter power switch to on and place the transmitter in the recharge cradle of the base. The transmitter goes in the base with the beltclip facing out.
- The recharge LED will light (Green if fully charged, Red if charging) and the In-Use Green LED on the base and transmitter will flash 3 times.
- The transmitter and base are now synched and will continue to be until another transmitter is linked to that base or the base is powered down.
- With the transmitter synched up, remove it from the cradle, plug in the lapel microphone (if used) and place the transmitter on your belt.
- To start the recording, press the In-Use button and the In-Use LED will light a constant green and you will hear a short beep
- To end recording, press the In-Use button and the In-Use LED will turn off and you will hear a short beep.
- At the end of your shift turn the transmitter off and replace it in the charging cradle.
- If you use the Transmitter too far away from the Receiver during recording, the transmitter will alert you with Audible warning beeps (two tone) and the In-Use LED will blink in red.
- Move closer to the receiver base and the link will be re-established once you return to normal range. The In-Use LED will light constant green when link is back to normal operation.
- If the link is not re-established within 30 seconds, the transmitter and receiver will return to standby mode.
- If you went out of range in Standby mode, or the unit reverted to standby mode, re-enter normal range and press the In-Use button. Operation will return to normal.
- If you will be out of range for a long period of time, turn the bodypack off.
- If the transmitter Low BATT indicator (red) starts flashing or you hear warning beeps, return the transmitter to its cradle on the receiver to fully charge the transmitter.
- The Charge LED indicator will light constant green when the unit is fully charged.
- The EMG or Panic Button can be programmed to do many things but may not be connected in your vehicle. Check with your technical department to understand what this button will control before you use it.
- In Record mode: Press the EMG button on the transmitter, a beep will sound and the relay will be triggered at the receiver.
- In Standby mode: Press the EMG button on the transmitter, a beep will sound, the green In-Use indicator will blink and the relay will be triggered at the receiver.