Zektor Palladia III™ 8X8 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Palladia III™ 8X8 Zektor
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 65 |
| Size: | 1.01 MB |
Show table of contents
Read manual
Document Outline
- Important Safety Instructions
- Version History
- What’s Inside
- Overview
- Using the Front Panel
- Using The HDA800(V2)
- RS-232 / TCP/IP Port Hardware
- Command Syntax
- Basic Control
- Advanced Control
- Reference for Advanced Control Commands
- Advanced Command Definitions
- ‘V’ Version
- ‘XS’ Control Settings
- ‘ACK’ Enable / Disable Acknowledgements
- ‘ECO’ Enable / Disable the ‘Parameter Changed’ Strings
- ‘CHM’ Enable / Disable always sending“.ch” masks on zone commands
- ‘CRE’ Enable / Disable trailing Carriage Returns Line Feeds
- ‘AUT’ Enable / Disable Auto Conversion of Analog / Digital Paths
- ‘MJP’ Enable / Disable Mute Volume Jump Option
- ‘UNV’ Unmute the Volume when a Volume Command is Given
- ‘SS’ Save Default Power On Settings
- ‘FS’ Reset to Factory Settings
- ‘LI’ Lighting Mode and Intensities
- TCP/IP Control
- ‘IPSET’ Set the IP operation mode, DHCP or STATIC
- ‘IPA’ Set / View the static IP Address
- ‘IPM’ Set / View the static IP Mask
- ‘IPG’ Set / View the static IP gateway address
- ‘IPAX’ Retrieve the current IP address in use
- ‘IPMX’ Retrieve the current IP mask in use
- ‘IPGX’ Retrieve the current IP gateway address in use
- HDMI Control Settings
- ‘EDLO’ EDID Lock
- ‘ESET’ Assign zones to an input source
- ‘KSIZI’ Set the number of HDCP keys of a source
- Audio Control
- Reference for Audio Control Commands
- Audio Command Definitions
- ‘MV’ Set Master Volume
- ‘VZ’ Set Zone’s Volume
- ‘VMIZ’ Set Zone’s Minimum Volume
- ‘VMAZ’ Set Zone’s Maximum Volume
- ‘VPZ’ Set Zone’s Volume as a Percentage
- ‘VRT’ Set Volume Ramp (Fade) Times
- ‘VMZ’ Mute a Zone using Volume Control
- ‘VMLZ’ Set a Zone’s Mute Level
- ‘VMT’ Set Muting (Fade) Times
- ‘BLZ’ Set Zone’s Balance
- ‘GAZ’ Set Zone’s Gain (Output Levels)
- ‘GAI’ Set Input’s Gain (Input Trimming)
- ‘BAZ’, ‘TRZ’ Set Zone’s Bass and Treble Levels
- ‘EQ1Z’, ‘EQ2Z’, ‘EQ3Z’, ‘EQ4Z’, ‘EQ5Z’ Set the 5 Band Equalizers’ levels
- ‘MXZ’ Stereo to Mono Down Mix for a Zone
- ‘DRZ’ Non-PCM Digital audio Routing
- ‘LSZ’ Set Lip Sync delay for a Zone
- ‘LSI’ Set Lip Sync delay for an Input