Hoshizaki C-100BAF - Manual (Page 24)

24
D. Setup
1) Position the icemaker in the selected permanent location.
2) Level the icemaker from side-to-side and front-to-rear by adjusting the feet.
E. Electrical Connection
WARNING
• Electrical connection must meet national, state, and local electrical code
requirements. Failure to meet these code requirements could result in death,
electric shock, serious injury, fire, or severe damage to equipment.
• This unit requires an independent power supply. See the nameplate for proper
voltage and breaker/fuse size. Failure to use a proper breaker or fuse can result
in a tripped breaker, blown fuse, damage to existing wiring, or component failure.
This could lead to heat generation or fire.
• THIS UNIT MUST BE GROUNDED: This unit is equipped with a 3-prong
grounding plug to reduce the risk of potential shock hazards. It must be plugged
into a properly grounded, independent 3-prong wall outlet. If the outlet is a
2-prong outlet, it is your personal responsibility to have a qualified electrician
replace it with a properly grounded, independent 3-prong wall outlet. Do not
remove the ground prong from the power cord and do not use an adapter plug.
Failure to follow these instructions may result in death, electric shock, or fire.
• Do not use an extension cord.
• To reduce the risk of electric shock, make sure the power switch is in the "OFF"
position before plugging in or unplugging the unit.
• To reduce the risk of electric shock, do not touch the power switch or plug with
damp hands.
• Do not use a unit with a damaged power cord. The power cord should not be
altered, jerked, bundled, weighed down, pinched, or tangled. Such actions could
result in electric shock or fire. To unplug the unit, be sure to pull the plug, not the
cord, and do not jerk the cord.
• The GREEN ground wire in the factory-installed power cord is connected to
a screw on the gear motor base where the cord enters the unit. If it becomes
necessary to remove or replace the power cord, be sure to connect the power
cord's ground wire to this screw upon reattachment.
• Usually an electrical permit and services of a licensed electrician are required.
• The maximum allowable voltage variation is ±10 percent of the nameplate rating.
• For optional drain pump (HS-5061) installation, refer to the instructions included with
the pump.