Hoshizaki C-100BAF - Manual (Page 29)

29
B. Startup
WARNING
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
NOTICE
• If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
• At startup, confirm that all internal and external connections are free of leaks.
1) Open the water supply line shut-off valve.
2) Make sure the power switch is in the "OFF" position. Plug the unit into the electrical
outlet. WARNING! To reduce the risk of electric shock, do not touch the power
switch or plug with damp hands. If you have to slide the unit back for a built-in
installation, make sure you do not damage or pinch the water supply line, drain
line, or power cord.
3) If required by sanitation code in your area, seal the perimeter where the machine
touches the floor with approved caulk compound in a smooth and easily cleanable
manner.
4) Move the power switch to the "ON" position to start the automatic icemaking process.
5) Once the unit starts to produce ice, allow it to run for another 30 minutes.
6) Move the power switch to the "OFF" position.
7) Remove the ice produced, then clean the storage bin liner, door liner, and door gasket
using a neutral cleaner. Rinse thoroughly after cleaning.
8) Move the power switch to the "ON" position to start the automatic icemaking process.
9) To confirm bin control operation, hold ice in contact with the bin control thermostat bulb.
If the icemaker does not stop within 10 seconds, the bin control thermostat must be
adjusted. Installations at higher altitude locations are more likely to require adjustment.