Hotpoint HDA2030 - Manual (Page 9)

This can be caused by either of
these reasons:
Not enough water is entering the the door. If there is no water in the bottom of the
dishwasher. dishwasher, check the supply to the dishwasher.
●
Is the dishwasher water supply on?
usually located under the sink.)
. Is the household supply turned on?
If you use well or cistern water, is the supply
If the water supply is try the cycle again. If
repeats, for service.
The drain pump could be the door. If there is standing water in the bottom of
temporarily blocked (usually the dishwasher, the door, touch then
caused by food particles such immediately touch to start the pump.
as cereal). If continues to appear, you may need do this
times to breakup the blockage.
The temperature sensor in the The temperature sensor to be replaced. for
dishwasher is not functioning service.
properly. Dishwasher may
continue to be used, but it will
You may continue to use your dishwasher. For best results
not heat water automatically.
adjust your household water heater thermostat to
or
Before you for
●
Try the cycle again to see if
Code reappears. The dishwasher
may correct itself.
●
Electronic controls can be
affected by outside interference.
Sometimes shutting off the power
to the dishwasher (at the fuse or
circuit breaker) will correct the
problem.
. Restore power after about five
seconds and try the cycle again.
. Check the guide above for things
you can do to correct the problem.
9