Home Automation II - Manual (Page 37)

Page 29
Status
The Status function is used to display the status of various items in the system. To enter the status menu, from the top-level
display or the main menu, press the 6 (STATUS) key on the console keypad.
STATUS
1=CTRL 2=ZONE 3=SUN
↓
4=TEST
5=TEMP 6=ENERGY
↑
1 = CTRL (CONTROL UNITS)
The Control Status menu allows you to view and scroll through the status of each control unit. To enter the Unit menu, from the
Status menu, press the 1 (CTRL) key in the console keypad. The system will display:
DEN
LAMP
STATUS OFF ↓
You may enter a unit number to start displaying the status of that unit, or simply press the down arrow key to scroll through the
list of units. The status display is as shown under Control, except that now the arrow keys may be used to continue scrolling
between units.
Porch Light 00:24:19
LAST COMMANDED ON
↓
You can also check the state and (if any) the remaining time duration of any Unit.
At this point, you may press the ' # ' key to control the unit as specified under Controlling Units.
2 = ZONE
The Zone Status menu allows you to view and scroll through the status of each zone input. To enter the Zone menu, from the
Status menu, press the 2 (ZONE) key on the console keypad. The system will display:
Front Door SECURE
ZONE 1 ↓
You may enter a zone number to start displaying the status with zone, or simply press the down arrow key to start with the first
zone. The arrow keys may be used to continue scrolling between zones. For each zone, the display will show the zone name, the
zone number, and the current status of the zone:
3 = SUN (SUNRISE / SUNSET AUTOMATIC CALCULATION)
The system automatically calculates the time of sunrise and sunset each day. From the status menu, press the 3 (SUN) key on the
console keypad to display the calculated time of sunrise, sunset, and the outdoor temperature (if outdoor temp sensor installed):
Sunrise: 6:00 AM Temp
Sunset: 5:58 PM 85
4 = TEST (SYSTEM DIAGNOSTIC TEST)
The diagnostic test performed by the OmniPro II allows you to check the status of the battery, telephone, bell circuit, auxiliary
fuse, and security zone loop readings. The display is updated 3 times per second, although the actual readings are taken 10 times
per second. To enter the Test menu, from the Status menu, press the 4 (TEST) key on the console keypad.
The first display shows the current battery reading and the phone line status. A battery test is initiated when the status mode is
first entered. The new battery reading is updated ten seconds later. The low battery limit is also displayed.
The phone status consists of two parts, separated by a "/". The first part shows the current phone line state: