Humminbird Legend 1000 - Manual (Page 14)

12
Simulator
S IMULATOR allows the L EGEND 1000
S ERIES
to operate in simulated
sonar mode. This is useful for
learning the features and functionality of the
L EGEND 1000
S ERIES
when not on the water. Settings to Control
Panels that are retained in normal operation will be
retained in Simulator Mode if a transducer is
connected. When operating with the Simulator on and
without a transducer connected, the Legend 1000
Series does not remember any changes to settings.
The Simulator setting defaults to factory settings after the
Legend 1000 Series is turned off.
Units
U NITS
selects the units of
measure for boat speed.
Selecting
KTS displays the
speed in nautical miles per hours; MPH displays the
speed in miles per hour. U NITS
selects the units of
measure for boat speed and depth in one of two
combinations supported by every
L EGEND 1000 S ERIES :
• F EET /MPH displays depth in feet and speed in miles
per hour.
• F EET /KTS DISPLAYS depth in feet and speed in nautical
miles per hour.
U NITS also selects the units of measure for boat speed
and depth in one of four additional combinations
supported by the International Models only:
• M ETRES /KPH displays depth in metres/speed in
kilometres per hour.
• M ETRES /KTS displays depth in metres/speed in nautical
miles per hour.
• F ATHOMS /KTS displays depth in fathoms/speed in
nautical miles per hour.
• F ATHOMS /KPH displays depth in fathoms/speed in
kilometres per hour.
The U NITS
settings are retained in memory after the unit is
turned off.
Language
L ANGUAGE (International Models
only) selects the language for
text used in the
C ONTROL P ANELS
and for messages. See the L EGEND 1005/1005 D EEP
Specifications for included languages.
L ANGUAGE setting is retained in memory after the L EGEND 1005 /1005 D EEP
is turned off. The factory setting is E NGLISH .
MAINTENANCE
Your L EGEND 1000 S ERIES
is designed to provide years of
trouble-free operation with virtually no maintenance.
Follow these simple procedures to ensure your
L EGEND
1000 S ERIES
continues to deliver top performance.
Cleaning
If the unit comes into contact with salt spray, simply
wipe the affected surfaces with a cloth dampened in
fresh water. Do not use a chemical glass cleaner on the
lens, as chemicals in the solution may crack the lens.
When cleaning the LCD protective lens, use a
chamois and non-abrasive, mild cleaner. Do not wipe
while dirt or grease is on the lens. Be careful to avoid
scratching the lens.
If your boat remains in the water for long periods of
time, algae and other marine growth can reduce the
effectiveness of the transducer. Periodically clean the
face of the transducer with liquid detergent. Pivoting
the transducer up in the bracket may allow better
access for inspection or cleaning.
Wetting the Transducer
If your boat remains out of the water for a long period
of time, it may take some time to wet the transducer
when returned to the water. Small air bubbles can
cling to the surface of the transducer and interfere
with proper operation. These bubbles dissipate with
time, or you can wipe the face of the transducer with
your fingers after the transducer is in the water.
Heat Damage
Never leave the
L EGEND 1000 S ERIES in a closed car or
trunk—the extremely high temperatures generated in
hot weather can damage the electronics.
MAINTENANCE AND WARRANTY
CONTROL PANELS / MAINTENANCE/TROUBLESHOOTING