HONDA MK SG-2 - Manual (Page 10)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 10
UNPACKING, TRANSPORT and ASSEMBLY
2. Cutting Drum Assembly:
Because the Cutting Drum assembly is a complex process, the assembly procedure will be broken into
several parts.
I. Cutting Drum Removal:
NOTE: Use care when removing the Shaft, Retaining Nuts to prevent the Retaining Nuts from falling inside
the Belt Guard.
(C)
Remove the Shaft Cover, Rear
Retaining Bolt and loosen the
Front Retaining Bolt using 9/16
wrenches and/or sockets
(B)
Locate the Shaft Cover,
Retaining Bolts
(A)
Rotate the SG-2 to rest on the
Handle/Stand
Handle/
Stand
(F)
Using a 15/16-inch socket,
loosen the Outer Shaft,
Retaining Nut
(E)
Remove the Shaft, Retaining
Nut Cover from the Belt Guard
to expose the Shaft, Retaining
Nuts
(D)
Pivot 126 781sc cm 6.48 6.72006 598.8 778.8 re W n 4 w 1 J 8 M /Cs1 CS 0 0 0 SC q 0.24 0 0 -.48 785i2etaining Bolt and loosen the