HONDA MK SG-2 - Manual (Page 35)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 35
MAINTENANCE AND TROUBLESHOOTING
(K)
Install the 3 Flat Washer
Spacers (if used) over the 3
Retaining Ring, Retaining Screw
holes
(J)
Obtain the Retaining Ring and
Flat Washer Spacers
Retaining
Ring
Flat Washer
Spacer
Flat Washer
Spacer
(L)
Place the Retaining Ring onto the
end of the Cutting Drum, aligning
the Retaining Screw Holes
Retaining
Ring
(M)
Install the 3 Retaining Screws
into the Cutting Drum (do not
cross-thread the screws)
(N)
Tighten the 3 Retaining Screws
using a 7/16-inch wrench
Turn clockwise
to tighten
Retaining
Screw
(A)
Install the Cutting Drum into the
SG-2; (See Cutting Drum
Change-out, Section 6)
Hold Cutting
Drum
Install
Shaft