HONDA MK SG-2 - Manual (Page 12)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 12
UNPACKING, TRANSPORT and ASSEMBLY
III. Cutting Drum Assembly:
NOTE: When rotating the Cutting Drum on end, ensure the open end of the drum is up.
(E)
Place the Retaining Ring and
Flat Washer Spacers in a secure
location
(D)
If present, remove the three Flat
Washer Spacers
Place in a
secure location
Flat Washer
Spacer
(C)
Continue with Step B until the
Cutting Drum assembly is
complete
(B)
Assemble the Cutting Drum
using Cutting Discs and Disc
Spacers (See Cutting Drum
Configuration, Page 21)
(A)
Pull the Cutting Disc Shafts out
the open side of the Cutting Drum
as shown
(F)
Install the 3 Flat Washer
Spacers (if used) over the 3
Retaining Ring, Retaining Screw
holes
(E)
Obtain the Retaining Ring and
Flat Washer Spacers
(D)
Place the Cutting Drum on the
closed end, with the open end
facing upward
Complete
Assembly
Open
End
Cutting Disc
Shaft
Cutting
Disc
Disc
Spacer
Rotate
Upright
Retaining
Ring
Flat Washer
Spacer
Flat Washer
Spacer