HONDA MK SG-2 - Manual (Page 17)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 17
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
SETUP:
1. Pre-start Inspection:
The pre-start inspection should be performed before beginning any job.
If Cutting Discs are worn, or are missing carbide inserts (carbide cutting discs only), replace the discs before
starting work.
NOTE: The carbide tips on carbide cutting discs are approximately 1/4-inch in length. When the carbide disc
is worn to the end of the carbide tip, the tip may fall out leaving a small hole.
(E)
Verify the SG-2 rolls freely
(D)
Verify the Height Adjusting
Wheel moves freely and the
SG-2 moves up and down
smoothly
(C)
Inspect the MK SG-2 for
general damage and/or loose
hardware
(A)
Inspect the Cutting Discs for
excessive wear and missing tips
Verify ease
of movement
(F)
Check for proper oil level
(See Maintenance section if low)
(B)
Inspect Engine for leaks
(H)
Check Air Filter for cleanliness
(See Maintenance section
if dirty)
(G)
Check for proper fuel level
(See Maintenance section if low)
Proper Oil Level
Low Level
Fill Throat
Look for leaks
Upper Limit
Missing
Tips
Wear
Verify ease
of movement
Air Filter