Front wheel change out, Maintenance and troubleshooting – HONDA MK SG-2 User Manual
Page 39
MK SG-2
Revision 11/01, Effective Date November 13, 2001
Page 39
MAINTENANCE AND TROUBLESHOOTING
15. Front Wheel Change Out:
NOTE: The two (2) Front Wheels should be replaced at the same time (MK Diamond Part No. – 138529).
(B)
Loosen the Retaining Collar of
each Wheel using a 5/32-inch
Allen Wrench
(C)
Move the Retaining Collars toward
the center of the Axle and then
slide the Axle out of the SG-2
(D)
Obtain 2 replacement Wheels
and remove the Dust Cover
from one side of each Wheel
(G)
Push the Retaining Collars
against the Front Wheels and
then tighten them with a 5/32-
inch Allen Wrench
(F)
Slide the Axle through one
Wheel, Install the 2 Retaining
Collars and then slide the Axle
through the second Wheel
(A)
Rotate the SG-2 to rest on the
Handle/Stand
Handle/
Stand
Rotation
Direction
(E)
Seat the Front Wheels into the
Wheel-well with the Dust Cover
side facing inward
Move Collars
toward the center
Direction of
Axle Installation
Retaining
Collar
Locking Collar
Allen
Wrench
Rotate counter-
clockwise to loosen
Axle
Direction of
Axle removal
Dust Cover
Installed
Dust Cover
Removed
Wheel
Installed
Dust Cover
Allen
Wrench
Rotate clockwise
to tighten
Locking Collar