Hitachi 65F710 - Manual (Page 73)

57” DISASSEMBLY/ASSEMBLY INSTRUCTIONS
73
2 - RE-ASSEMBLY PROCEDURE
STEP 8 To re-assemble the set, lift the top portion and align onto the
bottom cabinet. Gently lower the top portion until it sits flush
on the bottom. STEP 9 Re-install the joint connector bolts (4 pcs.) that were removed
in step 5 of the disassembly.
STEP 10 Re-install the top (4) four screws into the lower rear cover, see (a). Re-install the (4) four side screws that hold the back cover to the cabinet, see
(b).
(a) (b)
STEP 11 Re-connect the sensor connector to the sensor board, see (a). Re-install the sensor box, see (b).
(a) (b)
STEP 12 STEP 13
STEP 14 Re-install both of the front decoration panels, see (a) and (b). Re-install the speaker grille, aligning it with the bottom cabinet, see (c). This com-
pletes the Disassembly and Assembly instructions.
(a) (b) (c)
Please re-install 3 screws
(
ቢ,ባ,ቤ) below screen
frame that hold the back
cover to the cabinet as
the arrows shows.
Please re-install 3 screws
(
ቢ,ባ,ቤ) below screen
frame that hold the back
cover to the cabinet as the
arrows shows.
(a) Left Side (b) Right Side
Re-install 4 screws (
ቢ,ባ,ቤ,ብ) that hold the screen frame
to the cabinet on the Right side, see (a) and (b). Repeat to
re-install 4 screws on the Left side.
(a) ብ ቤ ባ ቢ
ቢ ባ ቤ ቤ ባ ቢ
ብ
(b)