Hitachi Koki USA DDC 52N - Manual (Page 107)

3-69
Chapter 3
Mak
in
g
C
o
pies
10. Selecting the Job Functions
Memory Recall
After a print cycle has been completed, Memory Recall allows you to run another print cycle again using
the same image data and copy settings as the previous one without having to reload the originals.
After the first print cycle, touch
on the Touch Panel to show a screen that allows you
to make the necessary settings.
Touch .
If you have any function to change, touch the
corresponding mode key and make the
necessary change.
Useful Tips
• The following functions can be changed when
running a print cycle again using Memory
Recall:
•Finishing •Orig. Copy
•Paper •Date
•Page •Distribution #
•Image Stamping •No. of copies
• A pen mark appears above the key of
the function changed.
• To change the number of copies to be made,
press the key and set the new number.
• Paper size and direction cannot be changed.
Press the Start key and the copier starts the
print cycle.
NOTES
• Memory Recall available from User's Choice
must be turned ON to use this function.
☞p. 4-15
• This function cannot be used in the Interrupt
mode.
• The preceding image data and copy settings
are cleared to disable Memory Recall when
any of the following operations are
performed:
- The copier is turned OFF.
- The copier scans a new original or the
Start key is pressed.
- The Access key or Interrupt key is pressed,
or Reserve is touched.
- The key or Panel Reset key is
pressed while the copier remains idle.
Useful Tip
After you have made copies from a confidential
document, it is recommended that you press the
Panel Reset key to erase the data.
Memory Recall
Setting Memory Recall
1 Memory Recall
1155O385CC
2
1155O386CA
▼
C
3
C