Hitachi Koki USA DDC 52N - Manual (Page 32)

2-14
Cha
p
te
r 2
G
et
ti
n
g
to
Kn
ow
Y
o
ur
C
opi
er
4. Control Panel Keys and Indicators
Control panel keys and indicators
Touch Panel
• Shows various screens and messages.
☞p. 2-16
Start Key
• Press to start the document scanning sequence.
• Press to start a print cycle.
• Lights up green to accept a print command;
lights up orange to reject one.
• Print lamp :
Lights up to indicate that a print cycle can be run.
• Scan lamp :
Lights up to indicate that a document scanning
cycle can be run.
10-Key Pad
Use to enter :
• The number of copies to be made.
• The various numeric values.
Clear Key
Press to:
• Reset the multi-copy entry to 1.
• Clear a zoom ratio entered when setting one from
the 10-Key Pad.
• Clear the original count, image data scanned, and
Access code.
Stop Key
Press to :
• Stop a print cycle.
• Stop a scanning cycle.
Access Mode Key
• Press to enter the access number. ☞ p. 2-20
* This key becomes valid only when Copy
Track of the Administrator mode available
from User
′
s Choice is set.
Energy Saver Key
• Press to set the copier into the Energy Saver
mode. ☞p. 2-19
HDD Lamp
• Lights up to indicate that the Hard Disk Drive Kit
(option) is being accessed.
Interrupt Key
• Press to interrupt a current job with a different
one.
• Press it again to return to the previous job.
☞p. 2-20
• Press to stop a multi copy cycle (except when the
copier is in an interrupt mode).
• Lights up to indicate that the copier is in the
Interrupt mode.
Panel Reset Key
• Press to set the copier into the initial mode,
clearing all settings made on the control panel.
☞ p. 2-19
* It does not, however, clear the contents of the
zoom and job program memory, Interrupt
mode, and the job held in reserve.
14 15
13
12
11
16 17 18
1
2
3
4
5
6
7
8
9
10