Hotpoint HDA2000M User Manual
Page 17
PROBLEM
POSSIBLE CAUSE AND REMEDY
CHIPPING OF CHINA
Rough handling can cause chipping. Load with care. Make sure glassware and china
are secure and can’t jar loose. (See page 12 for correct way to load glassware.) Make
sure tall glasses and stemware will clear the top of the tub when you push the rack into
the dishwasher. Always use the top rack for delicate items.
Use the CHINA-CRYSTAL cycle for fine china.
SMALL AMOUNT OF
Water around the outlet on the tub bottom at the back of the tub is normal. It is clean
WATER STANDING
water. It’s there to keep the water seal lubricated.
IN THE
OF THE TUB
WATER WON’T PUMP
If the entire bottom of the tub has water, you may have a drain problem. Clean the air
OUT OF THE TUB
gap, if you have one. (See page 18.)
Check the kitchen sink. Is it draining well? You may need a plumber.
If dishwasher drains into a disposer, run the disposer to clear. Be sure the disposer is
not clogged.
See the DISPLAY PANEL (pages 4 and 5).
SUDS IN THE TUB
detergents are not meant for dishwashers. USE ONLY
DISHWASHER DETERGENTS TO AVOID
To
remove suds from the tub:
Open the dishwasher. Let suds evaporate. Add 1 gallon
of cold water to the tub. Close and latch the dishwasher. To pump out water, touch
START two times, then immediately touch CLEAR-RESET.
Repeat if necessary.
DISHWASHER LEAKS
Suds can cause unit to overflow. That’s why it’s so important to use a detergent that’s
designed for automatic dishwashers.
Spilling the rinse agent can cause foam during washing. This can lead to overflowing.
(Wipe up accidental spill of rinse agent with a damp cloth.)
CONTROL PANEL
Shut off power to dishwasher at fuse or circuit breaker. Wait 5 seconds and restore
DOESN’T RESPOND
power to dishwasher. Try input panel again.
TO INPUTS
If
you need more help.. call, toll free:
GE Answer Center”
800.626.2000
consumer information service
17