Harbor Freight Tools 03733 - Manual (Page 7)

PRODUCT DESCRIPTION
1. The Tile Saw features a built-in water supply that keeps its Tile Saw Blade cool,
reduces dust and debris, and is easy to clean. Its efficient design returns water
directly to the reservoir and is accurate enough for most ceramic tile, quarry tile,
marble, terra cotta, and slate jobs. (See Figure B.)
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 12.
To Change A 4” Diamond Tile Saw Blade:
1. CAUTION: Make sure the Power Switch (part #4) is in its “OFF” position, and
the Tile Saw is disconnected from its electrical outlet before performing this
procedure. (See Figure B.)
POWER SWITCH (#4)
ON
OFF
LEVER (#9)
TABLE (#1)
SCREW (#16)
PARALLEL RIP FENCE (#7)
BLADE GUARD (#8)
ANGLE GAUGE (#21)
BENCH
STOP
(#22)
BODY
(#19)
CERAMIC TILE
(NOT INCLUDED)
FIGURE B
2. Remove the Screw (part #16). Then, remove the Table (part #1) from the Tile
Saw unit. (See Figure B above, and Figure C next page.)
3. Remove the Nut (part #38). Then, remove the Outer Flange (part #37).
(See Figure C.)
SKU 03733 PAGE 7 REV 10/05
Warning: Always wear ANSI approved, full face, safety shield and ear protection when
using this product.