Harbor Freight Tools 03733 - Manual (Page 9)

To Make Straight Cuts:
1. Remove the Screw (part #16). Then, remove the Table (part #1) from the Tile
Saw unit. (See Figure C.)
2. Fill the Body (part #19) with water. CAUTION: Make sure the water level is
high enough to cover the lower edge of the Tile Saw Blade (part #36), but
not above the maximum water level as indicated by the arrow.
(See Figure D.)
FILL WITH WATER AS INDICATED BY ARROW
DO NOT OVERFILL
FIGURE D
3. Reinstall the Table (part #1), and secure it in place with the Screw (part #16).
(See Figure C.)
4. Adjust the Parallel Rip Fence (part #7) to the width of cut desired. To do so, lift
up on each Lever (part #9) located at each end of the Parallel Rip Fence. Slide
the Parallel Rip Fence to the right or left until the desired width of cut is obtained.
Then, lock the Parallel Rip Fence in place by pressing down on each Lever.
(See Figure B.)
5. Plug the Power Cord (part #11) into a grounded, 120 Volt electrical outlet.
6. Turn the Power Switch (part #4) to its “ON” position, and allow the Tile Saw Blade
(part #36) to spin up to full speed. NOTE: Make sure the Tile Saw Blade is
picking up water from the Body (part #19) of the unit. If not, turn the Power
Switch to its “OFF” position, and unplug the Power Cord from its electrical outlet.
Then, check the water level. (See Figures B, C, and D.)
SKU 03733 PAGE 9