haier 311209J - Manual (Page 9)

Operation
311209J 9
Dispensing
1. Start pump. Fluid flow rate is controlled at pump.
Adjust pump pressure to obtain desired flow rate.
Use lowest pressure necessary to dispense fluid.
The pressure adjustment depends on hose length,
fluid viscosity, and nozzle size.
2. Disengage gun trigger lock.
3. Squeeze trigger in all the way. Fluid flow begins with
the slightest pressure on trigger and stops when
trigger is released.
Shutdown
1. Turn off all heat at controller.
2. Shut off fluid supply pump.
3. Trigger gun to relieve pressure while system is still
hot.
4. With gun over a waste container, hold trigger open
by securing with trigger retainer (Z).
F IG . 10: Trigger Lock Disengaged
Trigger Lock
Disengaged
TI8050
F IG . 11: Trigger Retainer Locked
Z
TI8051
TI8051b