HHB comm UDP-89 - Manual (Page 32)

Additional Features
31 UDP-89 User Manual Version 2.1 www.hhb.co.uk
Repeat All
This operates in a very similar way to Repeat 1. Further presses
of REPEAT from any transport mode (except Stop with DVDs or
SACDs) will enable Repeat All, confirmed by:
T01 0:49:29
Repeat All
REPEAT ALL
CD
The REPEAT ALL flag also illuminates (except in Stop Mode).
At the end of the disc, playback will immediately restart from the
start of the disc’s programme material (or in the case of DVDs,
the current Title). With CDs, Repeat All can be cancelled at any
time by pressing STOP. Note that when playing DVDs, pressing
STOP does not cancel Repeat unless it is pressed a second
time to cancel Resume Mode; alternatively, the function may be
cancelled by cycling through the options to Repeat Off.
Pause, FFWD and FREW transport modes can still be used
while Repeat All is set. Repeat All remains active even if the
play location is advanced/retarded through track/chapter
boundaries.
Selection of Repeat functions from the
OSD
With CDs and other disc types generating an on-screen browser
page (e.g. CD-ROMs containing audio files) - but not SACDs - the
cursor keys may be used to enable Repeat 1 and Repeat All.
The cursor keys can be used to navigate the yellow border from
the tracklist pane to the Filter pane and the Repeat field.
00:02:15/00:02:45
1/8 / Track01.CDA
Track01
Track02
Track03
Track04
Track05
Track06
Track07
Track08
Filter
Repeat : Off
Mode : Normal
Options:
Off
Single
Folder
All
JPEG Preview
Pressing MARK/ENTER with the Repeat field selected will cycle
the parameter through Off to Single, Folder, All and back to Off.
Setting the parameter to Single is equivalent to Repeat 1, as
described above; similarly, setting it to All is equivalent to
Repeat All.
Repeat Folder
A further Repeat option, Repeat Folder, is available for discs
containing files of type such as jpg. Selection of Repeat Folder
will cause the disc to play all the files in the currently-selected
folder repeatedly, but will ignore files in other folders, including
any nested within the currently-selected one.
Note: The on-screen display and the front panel display both
confirm Repeat status, regardless of the selection method.
Repeat A-B
The UDP-89 will continuously replay a segment of material
whose start and end points have been user-defined. Both start
and end points must be within the same track (or chapter); it is
not possible to define a loop across a track/chapter boundary.
Repeat A-B is enabled with the A-B button on the remote control
unit. The start and end points of the section to be repeated
are captured “on the fly”, with the unit in Play Mode. As the
programme material is playing, press the A-B button once at
the start of the section to be repeated. The display confirms the
selection for a few seconds as shown:
T03 0:01:10
Repeat A
REPEAT
CD
At the end of the segment to be repeated, press the A–B a
second time; the display again confirms briefly:
T03 0:01:39
Repeat A-B
REPEAT
CD
The playback location immediately jumps back to the point
defined as ‘A’, and the section of programme between points
‘A’ and ‘B’ will now be played repeatedly. Repeat A-B will remain
active until STOP is pressed, at which time, the display will
confirm cancellation of the Repeat mode:
T03 0:01:39
Rpt A-B OFF
CD