Harbor Freight Tools Power Tool Set 66755 User Manual
Page 18
Page 18
For technical questions, please call 1-800-444-3353.
SKU 66755
Clutch Cap
Set to
Drill
Torque Setting
Indicator
Figure C2
4. Set the desired torque setting by rotating
the Clutch Cap.
To drill holes, turn the torque Clutch Cap
a.
so that the drill icon is lined up with the
torque setting indicator.
The numbered settings from 1 to 23 are
b.
for driving screws, bolts and nuts.
It is recommended that a very low
•
torque setting be used for the first
drive, and adjust the setting as the
proper force required is determined.
The torque setting required depends
•
on the item being driven. In the case of
screws, consider the size, length, and
type of material.
If a pilot hole has been drilled into the
•
material, the torque setting required will
be less to drive the screw.
In addition to single or double-ended
c.
screwdriver bits, adapters with hexago-
nal shafts with matching socket heads
can also be used.
Fix the torque setting low enough to al-
•
low a safety margin.
operating the drill/driver
Insert the fully charged Battery Pack (1)
1.
into the base of the Drill/Driver, making
sure that it clicks into place securely.
Be sure the Battery Pack (1) is securely
seated into the Drill/Driver Handle so it
does not fall off during use.
Slide the Forward/Lock/Reverse Button
2.
(C10) (which should initially be centered
in the “lock” position) to either Forward or
Reverse as required.
If using the Drill to insert or remove
3.
screws, position the driver tip in the item
to insert or remove.
If drilling a hole, hold the Drill Driver
4.
above the area to drill.
Depress the Trigger Switch (C4) to start
5.
the drill.
When inserting or removing a screw or
6.
bolt, use slight pressure at first to keep
the screw driver bit in the head of the
screw or bolt and cause the screw or bolt
to thread into or unthread from the mate-
rial.
When drilling a hole, let the Drill/Driver
7.
do the work, using only enough pressure
to follow the drill as it cuts the hole in the
material.
When finished using the Drill/Driver, re-
8.
lease the Trigger Switch (C4), and center
the Forward/Lock/Reverse Button (C10)
to lock the trigger mechanism as a safety
measure.
Remove the Battery Pack (1).
9.
Clean then store the Drill/Driver indoors
10.
and out of children’s reach.