haier HWM50-10H - Manual (Page 10)

8
Preparation before washing
Confirm if
there's special
requirement for
the laundries. Clear the pocket.
Take out the
coins , sand,
hairpins etc. Fasten the
buttons and
zippers. When the pulsator
is running , the
buttons of the
l a u n d r i e s
m a y
cause noise. For
t h e s a k e o f
discretion, please
put the laundries
with buttons into
other laundries.
The quantity of
the laundries
shall not exceed
the rated value.
The big laundries
like the jeans
shall be put in
loosely.
Pay attention to followings before washing the laundries
a. Please check if the laundries are applicable for washing.
b. Separate those not colorfast from other laundries.
c. For laundries not water absorbing, please put them into water with hands.
d. For laundries with much soil, please remove the soil first. You can add detergent on the
part with serious soil directly. It is much easier to remove the soil by that mean.
e. For laundries likely to get lint ball or with long fiber, please first turn the inside out before
putting them into the water.
f. Do not put the laundries polluted with chemicals directly into the washing machine.
G. For those small laundries ,laundries likely to be twisted or worn, and woolen laundries,
please put them into mesh bag before washing.
h
. Do not select heating function for clothes that should avoid hot water or wear.
i . In order to prevent the heating band from being entangled, washing of seriously worn
or linty clothes should be prohibited.
Preparation before washing
1. Connect the water inlet hose.
2. Confirm that the washing machine is
earthed reliably. Then insert the power
plug into the receptacle. Do not connect
the earth terminal to the gas pipe and tap
water pipe.
3. Hang up the drain hose.
4.Slanting or uneven ground may result in
unstable working or abnormal noise. Please
make the machine stand horizontally.