haier HWM65-828 - Manual (Page 7)

<10cm <1.5m
5
> 30mm
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than
10cm, or the drainage will not be smooth, and
cost such long time that the machine may stop
at mid way.
2.Do not step on or press the drain hose.
4.If extra drain hose is needed, please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm, and the
length shall not exceed 1.5m.
3. If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
Usage of the drain hose
5.If the extra hose is too long, cut it either at A
or at B.
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in
unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable foot:
Fasten Loosen
High Low
the adjustable nut
the adjustable foot
1 .To twist the adjustable leg, please first lift up the
side of the foot slightly, loosen the adjustable nut,
and twist the foot.
2 . After adjustment, fasten the nut.
Adjust the Installation position
12
Press the button to select rinse . "RINSE " procedure
Press the WASH button to select wash . " " procedure
Press the button, the light flashes then press SET to select the desired wash time
from the STANDARD, HEAVY, CHILD, MEMORY programs 0-25mins .
"WASH " "+ - "
Press SET button can change the process ,can not change time from the GENTLE and
WOOL programs.
"+ - "
The button is unavailable from the SPEEDY and TUB DRY programs.
D "WASH" button
Press the button to select spin . "SPIN " procedure
Press the button, the light flashes then press SET to select the desired spin time
from the STANDARD ,HEAVY ,CHILD ,MEMORY programs 0-9mins .
"SPIN " "+ - "
The button is unavailable from the SPEEDY and TUB DRY programs.
Press SET button can change the process,can not change time
from the GENTLE and WOOL programs.
"SPIN"button ,then press "+ - "
E "SPIN"button
WATER
The washing machine can detect the laundries automatically. After detection, it will set the water level to suitable value
among 4, 6, 8,10 and 12 automatically. During the STANDARD program,You can also set water level by yourself. After
the machine is started, it will not set water level automatically. You shall push the
/PAUSE button to make new setting. " " START
If there's water inside the tub, the machine cannot detect the laundries and will display water level 6 .If wet laundries
are put in, it may display water level 12. You must set suitable water level by yourself.
During operation of SOAK,WASH and RINSE programs, you can push down the WATER LEVEL button to add water.
When you release the button, or it reaches the overflow water level, the machine will stop adding water.
The water level decided may be different from actual value because of the different moisture level of the laundries.
If SPEEDY program is selected, it will display water level 3 . It will display water level 4 when it rinses.
When STANDARD ,MEMORY ,HEAVY ,CHILD and GENTLE programs the rinse water value
will be one level higher than the wash water value.(Except 12 water value and when the rinse water value is
selected by yourself).
LEVEL
F WATER LEVEL button " "
G button " RYING" D "
Push the "AIR DRY" button The program is chosen(0.5h, 1.0h,2.0h).
It can dry the inner tub and the outer tub when 0.5h,1.0h are selected , which can avoid growing mildew
on the outer tub and the inner tub.
2.0h can dry laundries ,the max drying capacity of the fibre laundries is 1.5 kg.
to select air dry procedure.
"AIR DRY"program can not be reserved.
AIR DRY
The button is unavailable from the SPEEDY and TUB DRY programs.
Press the button, the light flashes then press SET to select the desired rinse times
from the STANDARD ,HEAVY ,CHILD ,MEMORY programs (0.1.2.3).
"RINSE " "+ - "
For GENTLE , press SET button can ,WOOL programs change
the process ,can not change time.
"RINSE"button , then press "+ - "
G button "AIR DRY"
H button "RINSE"
WASH
SPIN
RINSE
Under the wool program, only the 6 to12 water level can be selected.