Meridian Audio 8000 - Manual (Page 31)

26
CONFIGURING THE
DSP8000
LOUDSPEAKERS
Choosing standard settings
The DSP8000 loudspeakers provide the following five alternative standard
settings, called Types, which configure all aspects of the loudspeaker into
the most commonly needed configurations:
Type Description
1 For use with a Meridian control unit such as the 562V.2.
5 For use with a CD player connected to D1; all other sources use D2.
6 For use with a Meridian Surround Controller.
7 For use in a second room.
8 For use in the second or third room of a three-room system.
Types 2, 3, and 4 are for compatibility with 200/600 series units.
In all cases except Type 5, the D1 input is used for all sources.
Choosing one of the standard settings overrides any other configuration
you may have performed, and so can be used to reset the configuration of
the speakers.
To select a standard setting
• Switch off the DSP loudspeaker.
• Turn on the power again while holding down the 1 key on the remote.
The display will show the Type number.
For example:
Type 1
• Release the remote key.
The display will show:
L.
You should now specify the speaker’s position as follows.