Meridian Audio 8000 - Manual (Page 34)

29
CONFIGURING THE
DSP8000
LOUDSPEAKERS
Configuring the sources
When the master DSP8000 loudspeaker is set to one of the standard Types
the 12 source selection keys on the remote select inputs D1 and D2 as
shown in the table on page␣ 30.
If the configuration you want is not catered for by one of the standard
settings, you can configure each source individually.
The DSP loudspeakers provide 12 sources corresponding to the 12 source
selection keys on the remote:
CD, Radio, LP, TV, Tape1, Tape2, CDR, Cable, DVD, VCR1, VCR2, and
LD.
For each source you can configure:
• The label used for it on the front panel display, from a range of
alternative labels.
• The digital input it selects.
• The comms type and address, to identify other Meridian 500 Series
equipment.
• Other advanced options.
You only need to configure the sources on the DSP loudspeaker you have
specified as the master.
To configure a source
While in configuration mode:
• Press the source key on the remote corresponding to the source you
want to configure.
For example, to configure the Radio
source the display initially shows:
RD Radio
• Press > or < to step between options.
The right-hand set of characters shows the current value of the option.
• Press
A or V to change the value of the option.
When you have finished programming sources:
• Switch off at the back panel, and then switch on again to restore normal
operation.