FUJITSU LQFP-52P - Manual (Page 7)

4
■ MCU footprint design notes
Figure 3 shows the recommended footprint dimensions of the NQPACK mounted on the printed cir-
cuit board for the user system. Take the footprint in Figure 3 into consideration as well as the foot-
print of the mass production MCU when designing the printed circuit board for the user system.
To follow the most updated information, be sure to contact Tokyo Eletech Corporation whenever de-
signing the printed circuit board.
Figure 3 Recommended Footprint Dimensions for Mounting the NQPACK
No.1 Pin
13.
0 mm
2.
0 mm
0.65 mm 0.4 mm
9.
0 mm