Furuno GP-1850DF - Manual (Page 42)

4-4
Handling of Coaxial Cable
•
Do not touch the connector with bare hands;
use gloves.
•
Use radio pincers to remove, and pull out
straightly.
•
Plug in connector straightly.
3. Fasten the GR-7000A (DGPS beacon receiver) to the heat sink with four 3X8
screws as shown in the figure below.
Screws (3 X 8), 4pcs.
DGPS Beacon receiver
GR-7000A
GN-7707
Figure 4-4 Installation of DGPS beacon receiver
4. Open the cover of GR-7000A to connect two coaxial cables shown below.
J2
From GN-7707
J3
J1
Piece of shrink tubing
Cable Assy.
S.FL2-2LP0.7-D-WHT (250) (Supplied with DGPS kit)
Mini pin coax. cable
Figure 4-5 Connecting the coaxial cables in GR-7000A
5. Close the cover of GR-7000A passing the two cables out through respective
notches in the cover.
6. Plug PH6P-W-L240 connector to J2 on the GR-7000A through the cover.