Furuno MU-150HD - Manual (Page 33)

3. OPERATION
25
3. Press the S or T key to select [AUTO DIMMER].
4. Press the W or X key to select the adjustment interval.
5. Press the MENU key to close the menu.
3.6.2 How to adjust the brilliance from the external equipment
When FAR-21x7 series is connected to the [DVI-D1] or [DVI-D2] port, you can adjust the brilliance
of the display unit from the FAR-21x7 series connected.
Note: The auto dimmer must be off to use this feature.
1. Press the MENU key to show the main menu.
2. Press the X key to select [SYSTEM].
3. Press the S or T key to select [EXT BRILL CTRL].
4. Press the W or X key to set the desired input item.
[OFF]: You can not adjust the brilliance from the external equipment.
[DVI1]: When the DVI1 is displayed, the brilliance signal from DVI-D1 port controls this dis-
play’s brilliance. The /BRILL key is available for the screen other than the DVI1.
[DVI2]: When the DVI2 is displayed, the brilliance signal input from DVI-D2 port controls this
display’s brilliance. The
/BRILL key is available for the screen other than the DVI2.
[USB]: This is not available.
5. Press the MENU key to close the menu.
3.6.3 How to clear the memory
You can clear the memory to restore the default settings.
1. Press the MENU key to show the main menu.
2. Press the X key to select [SYSTEM].
3. Press the S or T key to select [DEFAULT RESET].
4. Press the X key.
The display is changed to "YES" from "NO".
Note: To cancel, press the W key. The display is changed to "NO" from "YES".
5. Press the X key to select "reset".
[OFF]: Not adjusted automatically
[1]: Every two seconds
[2]: Every 30 seconds [3]: Every minute
[4]: Every three minutes
[5]: Every five minutes
RGB DVI1 DVI2 VIDEO1 VIDEO2 VIDEO3 OSD SYSTEM
AUTO DIMMER
EXT BRILL CTRL
DEFAULT RESET
INFORMATION
RGB :
1280 * 1024 Fh : 80kHz Fv : 75Hz
DVI1 : 640 * 480 Fh : 31kHz Fv : 60Hz
DVI2 : NO SIGNAL
VIDEO1 : NTSC
VIDEO2 : PAL
VIDEO3 : NO SIGNAL
PROGRAM NO. : X.XX
OFF
OFF
YES
(OFF, 1~5)
(OFF
DVI1 DVI2 USB)
All custom settings will be lost.
←key: cancel →key: reset