Meridian Audio FDP-DILA2 - Manual (Page 54)

5
4
Menu Operations
* Factory set value
5
Press the EXIT button to return to the previous menu or press the MENU button to
exit the menu mode.
Note
• Refer to “Removing the Trapezoidal Distortion of the Image” on page 35 for more details about adjusting the keystone.
Adjustment item Button Adjustment content
Menu display 2 or 3
Sets whether to clear the menu display automatically or not.
15sec* : Clears the display automatically in about 15 seconds.
ON
: Does not automatically clear the menu display.
Line display 2 or 3
Sets whether to show the line display (Y/C, VIDEO, COMP, PC1, PC2 or DVI) on top
right of the screen or not when the VIDEO or PC button is pressed.
5sec* : Shows the line display for about 5 seconds.
OFF
: Does not show the line display.
Lamp time display 2 or 3
Displays the lamp use time.
ON* : Displays when the lamp use time reaches 1000 hours when set in the LPC or
LOC mode.
OFF : Does not display when the lamp use time reaches 1000 hours when set in the
LPC or LOC mode.3
Keystone ENTER
Press the ENTER button to enter the keystone submenu.
In the keystone submenu, press
2 or 3 to correct trapezoidal distortion of the
projected image. (–80 ↔ 0* ↔ +128)
To reset the keystone (trapezoidal distortion of the picture image) to the original
setting (factory set value: 0), press the PRESET button when the “Keystone”
submenu appears on the screen.
To exit the keystone submenu, press the EXIT button.
Lamp control ENTER
Press ENTER to enter the lamp control submenu.
Normal*
: Used as a normal lamp.
LPC : Automatically controls the power used by the lamp and increases it in
steps. When this mode is used, the brightness starts at approximately
70%. The decrease in brightness is slower than in “Normal” mode and this
mode is best suited when using the projector continuously for long periods
of time.
* “Lamp replacement” appears on the screen when the lamp use time
exceeds 2000 hours.
LOC : The brightness can be set in seven levels (-6 to 0). Since the brightness
can be set in steps, this is the mode best suited for adjusting multiple
screens. This setting can also be changed while the projector is being
used. To change the setting, choose LOC with the
5/∞ cursors and
choose the level with the 2/3 cursors.
Flip H 2 or 3
Reverses image right-to-left.
OFF* : For the front method.
ON
: For upside-down hanging from the ceiling.
Flip V 2 or 3
Inverses image upside-down.
OFF* : For normal setup.
ON
: For upside-down hanging from the ceiling.
RS-232C [bps] 2 or 3
Sets the baud rate for transmission.
9600
: 9600 bps
19200* : 19200 bps
Sleep time [min] 2 or 3
Sets the length of sleep time which automatically brings the projector into stand-by
state. You can select one of the sleep times: 15, 30, 60 and 0 (OFF*) minutes.