Farallon Communications PB 1400 - Manual (Page 5)

Installation 5
8. Using a Phillips screwdriver, remove the five screws that hold
down the heat shield. Remove the heat shield.
9. If a RAM card is present, gently lift up the RAM card (located to
the right of the keyboard ribbon cable) and set it aside. You need
to temporarily remove the RAM card to make room for the PB
1400 Ethernet Card. You’ll reinstall the RAM card later.
10. Remove the PB 1400 Ethernet Card from its antistatic bag,
handling the card by its edges to avoid touching the components.
11. Locate the internal expansion slot. (The slot is located to the
right of the keyboard ribbon cable.)
12. Insert the RJ-45 port on the card into the empty space on the
computer’s back panel (with the components facing down). Press
down lightly on the top of the card to help guide the Ethernet port
through the hole in the back panel. Do not seat the PB 1400
Ethernet Card yet.
Inserting the PB 1400 Ethernet Card