Farallon Communications PB 1400 - Manual (Page 8)

8 Chapter 1
Connecting to the network
After the PB 1400 Ethernet Card is installed in your Macintosh, the
next step is to connect it to your Ethernet network.
10Base-T
The PB 1400 Ethernet Card comes with a 10Base-T cable for
connecting to a 10Base-T Ethernet network. Plug one end of the
10Base-T cable into the port on the card, and connect the other end
to your Ethernet network.
Start up your Macintosh and check to see that the card's LED is lit.
(The LED is on the card’s bracket next to the port.) A steady green
light indicates that the card is receiving the link signal from the
network.
Bracket on the PB 1400 Ethernet Card