Fluke 700G - Manual (Page 16)

700G Series
Calibration Manual
6
Maintenance
How to Clean the Product
Clean the Product with a soft cloth dampened with water or water and weak soap.
WCaution
To prevent possible damage to the Product, do not use
solvents or abrasive cleansers.
WCaution
For safe operation and maintenance of the product:
• Repair the Product before use if the battery leaks.
• Remove batteries to prevent battery leakage and damage to the
Product if it is not used for an extended period.
• Be sure that the battery polarity is correct to prevent battery
leakage.
• Have an approved technician repair the Product.
How to Change the Batteries
XWWarning
To prevent possible electrical shock, fire, or personal injury,
batteries must only be changed in an area known to be non-
hazardous. Explosion hazard.
To change the batteries, see Figure 1:
1. Remove the Product holster.
2. Use a Phillips screwdriver to loosen the captive screw on the battery door.
3. Remove the battery door.
4. Replace the three AA batteries.
5. Install the battery door again.
6. Tighten the captive screw.
7. Put the Product back into the holster.
+
-
-
gvv002.eps
Figure 1. How to Change the Batteries