Important safety instructions, Safety warnings, Radio interference – Meridian Audio G Series User Manual

Page 2

Advertising
background image

P r e f a c e

i i

Important safety instructions

• Read the instructions.
• Keep these instructions.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Install only in accordance with the manufacturer’s instructions.
• Refer all servicing to approved service personnel.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE

This apparatus has been designed with Class 1 construction and
must be connected to a mains socket outlet with a protective
earthing connection (the third grounding pin).

This apparatus uses a single-pole power switch. As a result it is
not isolated from AC mains power when switched off at the rear
panel. The apparatus may be isolated from mains power either by
unplugging the power connector from the rear of the unit, or by
unplugging the connector at the opposing end of the power cord
or cable from its supply outlet. As a result, either or both of these
connectors should remain accessible

Safety warnings

• Do not expose the product to dripping or splashing.
• Do not place any object filled with liquid, such as a vase, on the

product.

• Do not place naked flame sources, such as lighted candles, on the

product.

To avoid interference

Do not position the product:

• Near strong magnetic radiation.
• Near to a television, or where connecting cables may be subject

to or cause interference.

To avoid overheating

• Leave at least 10cm around the equipment to ensure sufficient

ventilation.

Do not position the product:

• In direct sunlight.
• Near heat sources, such as a radiator.
• Stacked with any other audio products, as the heat it generates

may damage the other products.

• On a soft surface, such as a carpet, which would obstruct the

ventilation holes in the base.

The sides, base, and top of the G Series Power Amplifier case
contain venting holes for the internal heatsinks which should not
be obstructed. Ensure that air can flow around them. The product
normally runs warm to the touch when not in standby.

Radio interference

FCC Warning: This equipment generates and can radiate radio
frequency energy and if not installed and used correctly in
accordance with our instructions may cause interference to radio
communications or radio and television reception. It has been type-
tested and complies with the limits set out in Subpart J, Part 15 of
FCC rules for a Class B computing device. These limits are intended
to provide reasonable protection against such interference in home
installations.

EEC: This product has been designed and type-tested to comply
with the limits set out in EN55013 and EN55020.

G Series Power Amplifier 2

9/5/06 11:59:27 am

Advertising