Freedom9 IP 100 - Manual (Page 18)

Step 7 (Only required if using a local console)
Connect the keyboard to the PS/2 port marked as keyboard on the console side.
Step 8 (Only required if using a local console)
Connect the mouse to the PS/2 port marked as mouse on the console side.
Step 9
Connect the power supply on to the freeView IP 100.
3.3 Ethernet Connection
The rear side of the freeView IP 100 provides a RJ-45 connector for a 10/100 Mbps Ethernet
connection.
Using a 10 Mbps Connection
For 10BASE-T Ethernet networks, the Ethernet adapter uses Category 3, 4, 5 or 6 UTP cable. To
establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.
• Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.
• Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s
connector.
Using a 100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, the freeView IP 100 supports Category 5 or higher
UTP cabling. To establish a 100 Mbps connection, the cable must be connected to a
100BASE-TX hub or switch.
16