Meridian Audio DSP5000C - Manual (Page 25)

Operation 25
DSP5000C User Guide
C. 6
Press Play to action a programmed sequence.
Use with 504, 204 or 604 FM tuner
When a 204 or 604 is the system tuner, it can be controlled by the MSR
but only if the DSP5000Cs are set up in 200 mode (for example by
selecting Type 2. A 504 tuner can operate in both 200 and 500 modes.
Select the tuner with Radio. The display will show
rd. ##
where ## is the volume number. (If you are using another tuner which the
DSP5000C cannot control, see the setup section on page 36, select
Comms to ‘N.C.’)
To select a preset station, e.g. preset 4
1. Press 4
The DSP5000C will show a 'select cursor' display. For 500 mode the
display is:
P. 4
For 200 mode the display is:
S. 4
2. Either press Play or wait for a short time. The tuner will go to preset
number 4.
To select a higher preset, e.g. 23
1. Press 2 followed by 3
The DSP5000C will display
P. 23
and then the tuner will go to preset 23.
The master DSP5000C can display either the preset number of the tuned
station or its frequency. For example, if we tune to 92.3MHz and store this
frequency as preset number 3, we can then press Display repeatedly and
watch the master rotate its display between the following:
rd ##
P. 3
92.3
Note The DSP5000C cannot show the time displays of the 204.
6. Use the system, or put it into Standby.