FujiFilm WP-FXF500 - Manual (Page 42)

EN-10
6
When all is well, use a clean fingertip to apply the special silicone
grease. And then spread it on the surface of the O-ring until it is
completely covered.
Only use the special silicone grease
provided.
After applying the grease, check that
there is no sand or other substances
attached to the O-ring.
7
Close the waterproof case.
➀
Close the waterproof case and turn the
open/close knob in the direction of the
“CLOSE” arrow to seal it.
➁
Lock the open/close knob.
When closing the waterproof case, take
care not to catch your fingers or palm in
the waterproof case.
8
Dip the empty waterproof case into a water tank or a bathtub and
check for water leaks. For how to check it, see page 13.
If a water leak is detected …
➀
Immediately take the waterproof case out of the water and dry it on the outside.
➁
Make sure that there are no cracks in the waterproof case body. Check the O-
ring for attached foreign particles, flaws, cracks, odd shape, or twisting, and for
any foreign particles in the O-ring groove.
➂
When all is well, start over from the procedure on page 8.
If you find something wrong with the waterproof case, immediately stop using it and
contact your FUJIFILM dealer.
Preliminary check of the case
O-ring