FujiFilm WP-FXF500 - Manual (Page 55)

ENGLISH
EN-23
2
Remove old grease and foreign particles such as fibers and sand from
the O-ring.
➀
Wipe foreign particles off with a soft,
lint-free piece of cloth.
➁
Dry the rinsed O-ring without wiping
water again. This is to prevent fiber
attachment.
3
Pick up the O-ring with your fingers and feel it carefully, exerting only
light pressure, all along it to check whether or not there are any dents or
flaws caused by foreign particles or cracks due to deterioration (you can
feel these with the tip of the finger).
When pressing with your fingers and
sliding them over the O-ring, be careful
not to stretch it by pulling too tight.
4
Remove all foreign particles from the O-ring groove using a toothbrush
or cotton swab.
Make completely sure that no waste lint
from the cotton swab is left behind.
Examples of foreign particles and damage
Hair Lint Sand Dents caused by
foreign particles Flaw Crack