FujiFilm WP-FXF500 - Manual (Page 44)

EN-12
Positioning the Digital Camera in the Waterproof Case
3
Insert the silica gel pack into the space underneath the bottom of the
camera.
Make sure to insert the silica gel pack
correctly. If it is incompletely inserted, it
will prevent the O-ring from acting as a
seal, and water will leak in.
4
Confirm the following before closing the waterproof case.
• No part of the silica gel pack is
protruding.
• There is no dust, hair, or other foreign
particle on the O-ring, in the O-ring
groove, or on the edge face of the
waterproof case that engages with the
O-ring.
• The camera is correctly seated and
aligned in the waterproof case.
5
When all is well, close the waterproof case (pg. 10).
→ Check that the camera’s “ON/OFF” button can be correctly operated using the
controls on the housing.
When closing the waterproof case, take care not to catch your fingers or palm in the
waterproof case.
To prevent water leaks
Any foreign particles attached to the
O-ring may cause a water leak. Remove
the foreign particles (see page 22). If you
cannot remove them, replace the O-ring
with a new one.
Silica gel pack
Silica gel pack O-ring
Hair Lint Sand